Skip to content

Tile installation in Tampa, FL

Waterproofed first, then tiled.

We install and replace tile on floors, walls, backsplashes and showers across Tampa Bay. Where old tile has cracked, we fix the cause first.

Price
Quoted on site
Primary bath with a freestanding tub, glass shower and hexagon floor tile, South Tampa, FL
Modern custom home, South Tampa

What we do

Tile installation in Tampa is mostly preparation. The tile itself goes down quickly; the care goes into the surface under it. A floor has to be flat and stiff enough that the tile does not crack when the floor flexes, which can mean repairing the subfloor or laying an uncoupling membrane over a slab.

More on what we do

Walls in wet areas get cement board or a foam board system rather than drywall, and large-format tile needs a flatter surface than small tile, because any hollow under a big tile becomes a crack or a lip.

Layout comes next: where the cuts fall, how the pattern meets the doorway and which wall gets the full tiles. Those choices are settled before the first tile is set; then the tile is laid with spacers and leveling clips, grouted and, where the grout calls for it, sealed. Backsplash installation follows the counters: the tops go in first, and the tile starts from a level line above them so the grout runs true to the cabinets. Wood and vinyl floors depend on the same groundwork, covered under flooring installation.

Ceramic tile flooring installation follows the same method as porcelain, though the two tiles differ. Porcelain is denser and takes in almost no water, so it suits showers, entries and floors that meet the outdoors, while ceramic is softer, easier to cut and at home on walls and backsplashes. Natural stone such as marble needs sealing and a stiffer floor, and mosaic sheets go up faster than single small tiles but show any wave in the wall, so tile flooring in Tampa is chosen for the room before it is chosen for its look.

A backsplash has finishing details of its own. Its open ends take a bullnose tile or a metal edge profile, so no raw cut shows where the tile stops; a new backsplash can go over an old one only where the old tile is flat, secure and well bonded, and the added thickness then has to be finished at the edges. Joints wider than an eighth of an inch take sanded grout and narrower ones unsanded, and the grout is sealed, since it is porous and a kitchen splashes it every day.

Services we offer

  • Tile work installation
Flat and stiffTileUncoupling membraneSlab

What's included

  • Showers tiled over waterproofing built to spec
  • Subfloor and slab preparation, membranes and backer board
  • Porcelain, ceramic, natural stone and large-format tile
  • Layouts planned before the first tile is set

How a home remodeling project runs, step by step

What it costs

Deposit
In your estimate
The deposit is set in your written estimate, then milestone billing, so payments track completed work.
Permits
Depends on the job
Tile alone often needs none; shower and plumbing work is permitted with the city or county.
Warranty
2 years, in writing
A written workmanship warranty on every qualifying project, with coverage, exclusions and how to make a claim spelled out in your contract.
More on cost

Tile is priced more by labor than by the tile itself. Small mosaics, herringbone and diagonal layouts take far more cuts than a straight lay; large-format and natural stone take longer to set flat; and a shower adds its whole waterproofing system before the first tile. Tearing out old tile and fixing what it sat on comes first, so the site visit decides the figure, which reaches you in writing before work begins, with a deposit set in your written estimate.

Tile laid as part of a kitchen remodel or a bathroom is priced inside that project. Shower work usually comes with a plumbing permit, while a floor retiled on its own often needs none; we confirm what your address requires.

Fixr’s national figures, which our flooring installation cost guide cites, show where the labor goes: any pattern other than a straight lay adds 10 to 20 percent to the job, and large-format tile of 18 to 24 inches, glass and mosaic carry the highest labor of all, because each needs a flat, stable base and careful layout. A herringbone backsplash costs more than the same tile laid straight for that reason alone.

Showers and other wet areas

In a shower the tile is the finish, not the waterproofing. Water passes through grout, so the protection is a membrane behind the tile and a pan sloped to the drain.

  • Walk-in shower in marble-look tile with a brass rain head and niche, St. Petersburg, FL

    Marble walk-in showers

    Whole-home interior remodel, St. Petersburg

  • Freestanding tub under a crystal chandelier between the vanity and shower, St. Petersburg, FL

    Hexagon floor tile

    Whole-home interior remodel, St. Petersburg

  • Walk-in glass shower on dark gray tile with a window to the yard, St. Petersburg, FL

    Frameless glass

    Whole home renovation, St. Petersburg

More on showers

For bathroom tile installation, on our bathroom remodels or a shower alone, that waterproofing is built to spec and inspected before any tiling starts. Niches, benches and curbless entries are framed and waterproofed as part of the same system, and every opening for a valve or a shower head is sealed.

The St. Petersburg whole-home interior remodel shows the result: a marble walk-in shower with black hexagon tile on the floor. The Full Home Transformation set large-format tile and frameless glass in its bathrooms.

Three questions tell tile installers in Tampa apart on a shower. How will it be waterproofed, and is that membrane inspected before any tile goes on? How will the layout be shown to you before the first tile is set? And who replaces the valve, the drain or the pan if the job reaches them, since Florida leaves plumbing to a licensed plumbing contractor? Here that work runs under our own certified plumbing license, CFC1434279, so the shower is opened, plumbed, waterproofed and tiled under one contract.

What to know

Crack across tilesmovementDark grout lineswaterHollow-sounding tilea poor bond

Replacement

Tile work replacement starts by finding out why the old tile failed. Cracks that run across several tiles usually point to movement in the floor or the slab, while loose or hollow-sounding tiles suggest a poor bond.

More on replacement

Dark grout lines, stains on the wall beside a shower or a soft spot in the floor are signs of water. We take up enough to see the cause and price the fix in writing before new tile goes down, because replacing tile without fixing what cracked it only repeats the failure.

Matching existing tile is the other challenge. Discontinued patterns rarely match exactly, so a partial repair is often set in a new tile with a clear border, or the whole room is redone. Where a leak has damaged the floor itself, that flooring repair comes first.

Old tileSample, testedbefore removalSubstrate

Old tile

In an older house, what the old floor is made of is settled before it is broken up, because vinyl floor tiles and their adhesive can hide asbestos; our guide to renovating an old house lists the tests worth doing first.

More on old tile

On permits, the line falls between the tile and what sits behind it. Retiling a floor or a shower wall is finish work, which Hillsborough County lists among the jobs that typically need no permit, while replacing a shower pan, a valve or any piping makes it plumbing work, which the City of Tampa permits as a plumbing trade job; the state’s exemption for small jobs never covers plumbing. Our remodeling permits guide sets out the rest.

Which office that is depends on the address, not the mailing city. From our Tampa headquarters we tile floors, showers and backsplashes across Hillsborough County and into Pasco: inside Tampa the city issues the permit, Plant City, where the median home dates from 1989, and Temple Terrace run their own offices, and in Westchase or Brandon, outside any city, Hillsborough County does.

Questions

Can you replace a few cracked tiles?

Often, yes, if matching tile is available and the cause of the cracking is fixed. Where the original tile is discontinued, we show you the options, from a bordered repair to retiling the room, before work begins.

Do you tile showers?

Yes. Shower tile goes over a waterproofing membrane and a sloped pan, built to spec, the standard our bathroom remodels follow.

Can new tile go over old tile?

Sometimes, on a floor that is flat, solid and well bonded, where the added height works at doors and transitions. In a shower the old tile should come out, so the waterproofing behind it can be checked and rebuilt.

How are tile backsplashes installed?

After the counters are in. The wall behind them is patched flat, outlet boxes are brought forward so their covers sit on the tile, and the tile stops at a cabinet edge or a corner rather than in midair. Where the tile meets the counter, the joint is caulked instead of grouted, so the counter and the wall can move without cracking it.

How is an old tile floor removed?

In pieces, after any test an older floor calls for. The tile is broken out with the thinset beneath it; tile set in a thick mortar bed, or old glue-down vinyl under a floor being tiled, takes the longest, since the bed or the adhesive has to come off too. The bare slab or subfloor is then scraped clean, checked for the cracks or soft spots that failed the old floor, and flattened for the new one.

Is tile a good floor for a house in a flood zone?

It is the floor the code leans toward. On a house in an A zone that is substantially improved or substantially damaged, floors and walls below the required elevation must be flood damage-resistant, and porcelain set on a slab takes in almost no water, where laminate swells and wood cups. The guide to remodeling in a flood zone explains when that rule reaches a house.

How soon can we walk on new tile?

Thinset and grout need time to cure before the floor takes traffic. The timing depends on the products used, and you know it before the work starts.

Is the tile going on a floor, a wall or a shower?

Call us at (813) 536-5344Let’s talk