Skip to content

Kitchen countertop installation in Tampa, FL

Templated in place, then cut to fit.

We install quartz, granite and natural stone countertops across Tampa Bay, in new kitchens and existing ones. Each top is cut from a template taken off the installed cabinets.

Typical range
$1,400 to $5,250

National range for the 35 square feet of counter in Fixr’s example kitchen. Source: Fixr (opens in a new tab), checked November 12, 2026.

Smooth glass cooktop set into veined stone over navy drawers, Trinity, FL
Kitchen remodel, Trinity

What we do

Kitchen countertop installation in Tampa follows the cabinets, not the other way around. Once the boxes are set, leveled and fastened, a template is made on them; the slabs are cut and their edges polished at the fabrication shop, then carried in, set, seamed and sealed. In our Dover kitchen remodel, the wood cabinets and the long island stood bare under the pendants until the stone arrived.

More on what we do

Flat-pack cabinets take stone the same way once they are set, and our guide to IKEA kitchen remodel cost prices quartz on that route.

Replacing only the tops is a smaller job with its own care. The old counters come off without prying the cabinet frames apart, the sink and cooktop are disconnected, and a tiled backsplash usually comes away too. A dishwasher once screwed to a laminate top is refastened to the cabinet sides, since stone takes no screws. Where new cabinets come too, the counters are one stage of a kitchen remodel.

Before comparing countertop quotes in Tampa, ask who makes the template and when, where the seams will fall and whether you see them before the stone is cut, and who disconnects and reconnects the sink, the faucet and the disposal. Ask too who pays to fix a slab that arrives chipped or cut wrong. Here the template is made on cabinets already set and fastened, the seams are placed in straight runs, and the plumbing is reconnected under our own certified plumbing license, CFC1434279.

Our written 2-year warranty covers the installation itself, the level of the tops, the seams, the supports and the plumbing we reconnect, while any warranty on the slab comes from its maker and is handed over separately.

Templates and installations run from our Tampa headquarters across Hillsborough County and into Pasco, so a kitchen in Brandon or Carrollwood gets the same two visits, the template and then the installation, as one inside the city.

Services we offer

  • Kitchen Countertop Installation
Corner of white shaker cabinets and veined counters between the fridge and range, St. Petersburg, FL
Kitchen remodel, St. Petersburg

What's included

  • Kitchen countertop installation on new or existing cabinets
  • Quartz, granite, natural stone and porcelain tops
  • Templates made once the cabinets are set and fastened
  • Seams kept clear of sinks and cooktops
  • Eased, mitered and waterfall edges
  • Old counters removed, sinks and faucets refitted

How a kitchen remodeling project runs, step by step

What it costs and how long it takes

Deposit
In your estimate
The deposit is set in your written estimate, then milestone billing, so payments track completed work.
Timeline
Project-specific
The template is made once the cabinets are set and the tops follow when the slabs are cut; setting them is usually one day.
Permits
Rarely needed
New tops on an unchanged layout generally need none; a sink, gas line or circuit that moves is permitted work.
Warranty
2 years, in writing
A written workmanship warranty on every qualifying project, with coverage, exclusions and how to make a claim spelled out in your contract.
More on cost and timeline

Countertops are priced by the square foot of slab and then by the work cut into it. The material and its thickness set the base; each cutout adds shop time, a mitered or waterfall edge adds more, and tearing out an old stone top takes longer than lifting off laminate. Measurements taken at your home set the price, and the deposit is set in your written estimate.

Two visits frame the wait, the template and then the installation, with the kitchen short of counters between them. Where only the tops change, the sink is out of use until the new one has cured to the stone and been plumbed again. Our kitchen remodel cost guide lists countertop prices by material.

Fixr’s example kitchen carries 35 square feet of counter, a useful yardstick when reading a quote priced by the square foot. A short run, a bar top or a vanity may fit a remnant slab, which is worth asking about before a full slab is bought for a small piece.

What to know

QuartzGraniteEven color, no sealerEach slab its own, sealed

Stone choices

Quartz is an engineered slab of ground stone bound with resin, so it needs no sealer and its color runs true from slab to slab, though a hot pan can scorch the resin. Granite is quarried, no two slabs match, and a penetrating sealer keeps oil and wine from soaking in.

More on stone choices

Marble is softer and etches under lemon juice; porcelain slabs are hard and shrug off heat, but many carry their pattern only at the surface, so their edges are mitered.

Our own kitchens cover much of that range: quartz on the Valrico farmhouse remodel’s long wood island, stone running to the floor at both ends of the Modern Custom Home’s island, and a smooth cooktop set flush into veined gray stone in Trinity. The stone itself is chosen during kitchen design.

Natural stone is worth choosing from the full slab, where its veining and depth show in a way a small sample cannot, and the stone yards around Tampa Bay keep hundreds of quartz colors in stock alongside the granite and marble.

SeamSinkCooktop

Seams and edges

Few kitchens fit on one slab, so most counters carry a seam, and the template decides where it falls. A seam belongs in a straight run, clear of the sink and the cooktop where water and heat would work at the joint, and never through the narrow strip in front of a cutout.

More on seams and edges

Epoxy tinted to the stone fills it, and clamps draw it flat and tight, so it reads as a line rather than a gap.

Edges and cutouts are shaped at the shop. An eased edge, its corner just softened, chips less than a sharp square one; a mitered edge adds a strip beneath the top so the slab looks thicker, which is also how a waterfall end meets the counter. An undermount sink hangs from the stone, so the sink and faucet are chosen before templating, and the tile backsplash goes up after the tops are set.

The template records the room as it is, where a wall bows or a corner strays from square, so the stone is cut to the kitchen rather than to a drawing of it. An undermount sink also needs the inside edge of its cutout polished, shop time a drop-in sink does not take, and a full slab can weigh more than 500 pounds, so the pieces are carried in and set by a crew with the equipment for it.

StoneLevel lineDips

Existing cabinets

Stone weighs far more than the laminate it often replaces, so cabinets that stay are checked before anything is templated. A sink base swollen by an old leak or a run that dips will show up in new stone as a crack or a rocking top.

More on existing cabinets

Seating that reaches past what the stone can carry alone needs hidden steel supports or corbels.

A full-height slab backsplash, like the veined white one behind the Wimauma kitchen’s counters, is templated with the tops and needs a wall flat enough for the stone to sit tight, with each outlet brought forward to meet it. Where the old cabinets are too worn for new stone, a kitchen cabinet installation comes first.

What homeowners say

“super happy with how the quartz countertops look tbh.”

Elijah R, kitchen remodelingBBB review by Elijah R, on the Better Business Bureau (opens in a new tab)

More reviews

Questions

Can new countertops go on our existing cabinets?

Often, when the boxes are level, solid and dry. A swollen sink base or a racked cabinet is replaced first, because stone will not bridge a weak box the way laminate did. If the layout is changing, the counters wait for the new cabinets and are templated once those are set.

Is quartz or granite better in a Florida kitchen?

Both handle daily cooking, and humidity troubles neither. Quartz needs no sealing and shrugs off stains but wants a trivet under hot pans; granite takes heat better and needs its sealer renewed from time to time. The choice usually comes down to pattern and how much care you want to give it.

Do we need to choose the sink before templating?

Yes. An undermount sink is cut around its own model and the faucet holes are drilled for the faucet you pick, so both are on hand when the template is made. A cooktop or a slide-in range works the same way: its cutout or its gap follows the appliance’s own instructions.

Can we choose the exact slab?

For granite and marble it is worth doing, since no two slabs match and the veining you saw in a sample may not be the veining on your island. Quartz runs true in color from slab to slab, so a sample is usually a fair picture of the counter you will get.

Should kitchen counters be 3 cm or 2 cm thick?

In Tampa kitchens 3 cm, about an inch and a quarter, is the usual stone, because it needs no plywood beneath it. 2 cm is common on bathroom vanities, and on a kitchen counter it takes a laminated or mitered edge to look as thick as the 3 cm slab.

What happens on installation day?

The old tops come off, the new pieces are carried in, set level on the cabinets, seamed and sealed, and the sink is mounted to the stone. The faucet and disposal are reconnected once the sink’s adhesive has cured, the cooktop or range goes back into its cutout or gap, and the backsplash tile follows on a later day, once the tops are set.

Do you install bathroom vanity tops too?

Yes, from the same stones. A vanity top is often the thinner 2 cm slab, and a kitchen counter and a vanity cut from one slab keep their color matched, which is one reason to plan them together, as our kitchen and bathroom remodeling page explains.

Do you install countertops in condos?

Yes. Counters inside the unit are yours to replace within the building’s rules, and the slabs come up by the building’s elevator in the hours the association allows, so the installation day is booked with the building as well as with you. Our condo remodeling page covers the association’s side.

Granite, quartz or porcelain: which suits the way you cook?

Call us at (813) 536-5344Let’s talk