Skip to content

Kitchen remodeling in Palm Harbor, FL

Palm Harbor kitchens, facing the yard.

We open Palm Harbor kitchens to the lanai with wider windows, doors and pass-throughs. Each opening is engineered for the 145 mph wind speed the county’s licensing board set.

The Salt & Pepper Construction crew in black company polos in front of a modern two-story home
The Salt & Pepper crew

The window over the sink

Half of Palm Harbor’s houses went up in 1985 or earlier, so in many a Palm Harbor house the window over the sink has sat in its wall for about four decades. Glass cut into that wall during a kitchen remodel answers to a far newer figure: 145 mph, the ultimate design wind speed that a local amendment by the county’s licensing board sets for Risk Category II buildings, the class ordinary houses fall in, across incorporated and unincorporated Pinellas alike.

An engineer turns that speed into a design pressure for the window’s exact position, because a corner or a tall gable takes more push and pull than the middle of a low wall. The unit ordered has to carry a tested rating at or above that pressure, and the same calculation sizes the header over the wider opening and the fasteners that hold the frame.

More on over the sink

Glass gained over the sink is wall lost to kitchen cabinets. Every extra foot of window removes a foot of uppers on that wall, so the cabinet plan is laid out around the rough opening the engineer approves, and the storage it gives up usually returns as a pantry wall or deeper drawers.

What to know

A door out to the lanai

The bigger change is a door. Replacing the glass over the sink with a sliding glass door or a pair of French doors to the lanai cuts the wall from the slab up to a fresh header. It becomes the largest gap in the kitchen’s exterior, and it takes the floor where a base cabinet run, and often the sink, used to stand.

More on lanai door

That door answers to the same 145 mph figure as the window it replaces, through a design pressure worked out for its own place on the wall, and it also has to keep wind-driven rain out at the sill. In a concrete block wall, cutting the opening down to the floor calls for a lintel across the top and reinforced cells at each side, both detailed on the engineer’s drawing.

The rest of the kitchen then rearranges around the door: the sink moves to an island or to another wall, the cabinet run is redrawn, and the floor finish is carried right to the threshold.

A pass-through to the patio

For kitchen remodeling in Palm Harbor, a pass-through window over the counter, opening onto a patio bar or an outdoor grill, is still a window as far as the code is concerned. It is held to the 145 mph figure like the one over the sink, however much of the year it stands open.

More on pass-through

Its hardware is where the choice narrows. Folding, sliding and awning units are each tested at particular sizes, and their rated pressures vary with the type and the width, so the kitchen design picks from the units whose rating clears the pressure calculated for that wall. A very wide opening may be split by a rated mullion into two units, and the counter beneath is set to the sill height the chosen unit needs to seal.

Kitchens in houses from the mid-1980s

A Palm Harbor kitchen of the community’s median age can have a breakfast area beside a slider to the lanai, cabinets along two or three walls and a single window over the sink, which is why the openings above come up so often here.

More on 1980s kitchens

The rest of the room is the usual work of a kitchen near forty: new boxes or new fronts, stone in place of laminate, lighting under the uppers and over the island, and added circuits for appliances its first wiring never anticipated.

Inside that shell the job covers the rest of a full kitchen: kitchen cabinet installation on a new layout, kitchen countertop installation in quartz or granite, tile, lighting and the plumbing and electrical changes the plan calls for, all under one Seminole contract.

County permits and how long they take

With no city government, Palm Harbor’s kitchens are permitted by Pinellas County Building and Development Review Services through the county’s Access Portal, and the county’s own figure for a typical residential permit is about 14 days.

More on county review

A kitchen that keeps its walls and openings may need no permit at all, but one that adds the lanai door, the pass-through or the larger window described above is a residential permit with engineered openings, and that wait is planned into the schedule before demolition is booked.

Condo kitchens and the outer wall

An estimated 20.7 percent of Palm Harbor’s housing stands in buildings of five or more units, and in those, the wall a window or a pass-through would cut through is usually part of what the declaration holds in common, so the association decides any new opening long before the wind speed does.

More on condo walls

Inside the unit, the kitchen is redrawn freely within the association’s rules for work hours, deliveries and contractor insurance, and the openings stay as the building made them.

How a Palm Harbor kitchen job runs

Our Seminole office begins with a free visit, measures each opening the plan would add or enlarge, and has the engineer work out the design pressures before the kitchen design is costed, so the windows and sliders we order already carry ratings that clear their spots.

More on job steps

Questions to put to any bidder here: whether the quoted window or door carries a tested rating at or above the pressure for its spot on the wall, who produces that calculation, and whether the header and fasteners it calls for are in the price.

What it costs

Price ranges
By scope
Our kitchen remodel cost guide sets out what a kitchen remodel costs in Florida, by scope and by line item.
Deposit
In your estimate
The deposit is set in your written estimate, then milestone billing, so payments track completed work.
Changes
In writing
A written change order with the cost and schedule impact before any added work.
Warranty
2 years, in writing
A written workmanship warranty on every qualifying project, with coverage, exclusions and how to make a claim spelled out in your contract.

Questions

Is a Palm Harbor kitchen held to a different wind figure than one inside a Pinellas city?

No. The licensing board’s amendment covers incorporated and unincorporated Pinellas County alike, so a new opening in a Palm Harbor kitchen is designed to the same 145 mph as one in Clearwater or Dunedin. The pressure on each unit still differs from one address to the next, because it depends on the wall height, the roof shape and where the unit sits.

Does a Palm Harbor kitchen need a county permit?

Finishes and new boxes on the same layout generally need none; added circuits, a relocated drain, a partition taken out or any new or enlarged opening go to Pinellas County for a permit through its Access Portal.

Can a pass-through window stay open through the summer?

It can be opened whenever you like, but it is designed and rated as a closed window for the storm, so its hardware, its rating and the sill it seals against are chosen for the 145 mph figure regardless of how often it stands open.

How long does a Palm Harbor kitchen with a new lanai door take?

Longer than one that keeps its openings: the engineer’s pressures come first, then the county’s residential review, and the door itself is ordered to the approved size, so its lead time is often the longest item on the schedule.

Can my condo kitchen in Palm Harbor get a bigger window?

Only with the association’s approval, since the outer wall usually belongs to the building, and then with the same engineered rating any new window in the county needs.

Is Palm Harbor served from your Seminole office?

Yes, along with Dunedin and Tarpon Springs on either side of it.

What does a Palm Harbor kitchen with new openings cost?

More than one that keeps its walls, since each new opening carries the engineer’s calculation, a rated window or door, a new header and the patching around it, and the written estimate lists each opening on its own line.

Can a Palm Harbor kitchen be remodeled in phases?

Yes. The openings, which need the engineer and the county’s permit, can come first, with cabinets and stone following on the same permit, or the finishes can be done now and the openings left for a later permitted phase.

Sources

Sources checked November 12, 2026

  1. 1.

    A Pinellas County Construction Licensing Board local amendment sets the ultimate design wind speed for all incorporated and unincorporated Pinellas County at 145 mph for Risk Category II buildings, with interpolation allowed (135 mph for Risk Category I, 155 mph for III and 157 mph for IV). Florida Building Commission (floridabuilding.org), Local Amendments to the 8th Edition (2023) Florida Building Code, Structural, Pinellas County Construction Licensing Board entry for Section 1609.3 (opens in a new tab)

  2. 2.

    Homes in Palm Harbor have a median year built of 1985, with a margin of error of 1 year (2020-2024 American Community Survey). US Census Bureau, American Community Survey 5-year estimates 2020-2024, table B25035 (Median Year Structure Built), Palm Harbor CDP, Florida (opens in a new tab)

  3. 3.

    Palm Harbor is unincorporated, so Pinellas County Building and Development Review Services issues its residential permits, and applicants must apply through the Pinellas County Access Portal (Accela). Pinellas County says express permits take 0 to 2 business days, residential permits typically take about 14 days, and commercial permits take around 21 days. Pinellas County, Applying for a Building Permit (opens in a new tab)

  4. 4.

    An estimated 6,337 of the 30,595 housing units in Palm Harbor, or 20.7 percent, are in buildings with five or more units (computed from the survey counts and rounded to one decimal). US Census Bureau, American Community Survey 5-year estimates 2020-2024, table B25024 (Units in Structure), Palm Harbor CDP, Florida (opens in a new tab)

Call our Seminole office at (813) 330-2684Let’s talk